Wifi pineapple forum4/3/2023 ![]() ![]() Reset the WiFi Pineapple facing USB Ethernet interface back to DHCP or 172.16.42.42 with netmask 255.255.255.0 Once complete, the WiFi Pineapple will restart. Do not interrupt the power supply while the firmware is updating. With the RESET button held, power on the device.Ĭontinue holding the RESET button for 10 seconds, then release.Ĭonnect the host PC to the WiFi Pineapple via the USB Ethernet Portįrom the host PC, configure a static IP address on the WiFi Pineapple facing Ethernet interface to 192.168.1.2 with netmask 255.255.255.0įor example, in Linux run ifconfig eth1 192.168.1.2 netmask 255.255.255.0 up (where eth1 is the interface name of the WiFi Pineapple).Ĭlick Choose File and select the factory firmware image downloaded above. Unplug the WiFi Pineapple completely from all power sources.īegin holding the RESET button on the device. ![]() ![]() Next, follow these steps to access the recovery web interface and update the firmware. Has anyone else had problems like this? I’ve done a few factory resets, I’ve even tried the firmware update again but after following these instructions: Everything went well with the firmware update and I’ve gone through a plethora of tutorials and videos on the first usage, but… I can’t add clients to the client module, it just stays blank, even after a refresh.Īlso, the probe logging is a little hit and miss. I’ve been looking forward to getting one, it finally turned up. I was wondering if anyone else here had a WiFi Pineapple? ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |